Operating conditions of high speed braiding machine

What are the operating conditions of the high speed braiding machine? I believe that many people are very concerned about this issue. The following editor will give you a brief introduction, let's take a look!

1. High speed braiding machine stops suddenly during the knitting process. The high speed braiding machine stops suddenly during the knitting process because the thread is broken or the thread has been used up. After the corresponding treatment is done, the machine can be turned on to continue knitting.
2. Treatment of the shielding layer of high speed braiding machine that does not meet the specified requirements. During the preparation process of high speed braiding machine, if the shielding layer being braided does not meet the specified requirements, it should stop at any time to remove the braiding of the metal wire in this length, and then dispose After finishing, resume normal knitting.
3. The high speed braiding machine should be produced in strict accordance with the quality control requirements in the knitting process. Strictly follow the process card regulations issued by the company to the high speed braiding machine workshop, control the process parameters and make inspection records.
4. Marking the splicing of the high speed braiding machine wire During the working process of the high speed braiding machine, a complete reel requires one end to the end. If there is a joint inside that needs to be cut, the reason must be indicated in the middle of the mark and the front section must be written. length.
In the operation of the high speed braiding machine, in order to improve the quality and work efficiency, the cables should be neatly arranged and arranged tightly, so as not to cross the phenomenon of ups and downs.